Compact 4-inch-long spade bit for drilling in tight quarters where a standard 6-inch bit will not fit. Use it inside finished cabinets, between joists, in close-quarter remodels, and on right-angle drills where the head crowds the bit. Bores clean, fast holes in framing lumber, plywood, soft hardwoods, and most wood-based materials.

• Cutting diameter: 1-1/2"
• Overall length: 4"
• 1/4" hex quick-change shank fits all standard hex chucks and quick-change adapters
• Hardened high-carbon steel construction stays sharp longer than mild-steel bits
• Raker spurs with 15-degree cutting wedge bore faster, smoother holes
• Tri-point tip with center spur for accurate, walk-free starts
• Flat ground cutting zone -- re-sharpen with a common flat file
• Heavy-duty single-piece construction shank eliminates flex and bit wobble
• Black oxide finish resists corrosion in damp framing and weatherized job sites

Tip: The 1-1/2" diameter is sized for 1-1/2" PVC drain rough-in, large pass-throughs for vent runs, door-knob and lock-set face bores. Step up to the 6" length for general framing work where the bit can clear, or to the 12" length when drilling through double top plates or back-to-back stud bays.

FOR CALIFORNIA SHOPPERS

Hello Californians! Your government wants us to show you the following message:

• ⚠  WARNING: This product and the dust created by its use may contain chemicals including lead known to the State of California to cause cancer birth defects or other reproductive harm. For more information go to www.p65warnings.co.gov