Long 12-inch spade bit for through-stud reach -- single-pass drilling across double top plates, stacked headers, and back-to-back stud bays for electrical cable and plumbing supply runs. Standard length for cable-fishing and rough-in work where a 6-inch bit cannot reach the back of the bay.

• Cutting diameter: 1/2"
• Overall length: 12"
• 1/4" hex quick-change shank fits all standard hex chucks and quick-change adapters
• Hardened high-carbon steel construction stays sharp longer than mild-steel bits
• Standard arched cutting spurs define a clean hole edge and clear chips quickly
• Tri-point tip with center spur for accurate, walk-free starts
• Flat ground cutting zone -- re-sharpen with a common flat file
• Heavy-duty single-piece construction shank eliminates flex and bit wobble
• Black oxide finish resists corrosion in damp framing and weatherized job sites

Tip: The 1/2" diameter is sized for 1/2"-13 hardware clearance, NM-B 12/2 and 14/2 cable runs through framing, 1/2" PEX rough-in. For close-quarter remodel work, drop down to the 4" Stubby or the 6" standard length.

FOR CALIFORNIA SHOPPERS

Hello Californians! Your government wants us to show you the following message:

• ⚠  WARNING: This product and the dust created by its use may contain chemicals including lead known to the State of California to cause cancer birth defects or other reproductive harm. For more information go to www.p65warnings.co.gov