CENTURY DRILL LAZER SPADE BIT, STUBBY - 1/2"Compact 4-inch-long spade bit for drilling in tight quarters where a standard 6-inch bit will not fit. Use it inside finished cabinets, between joists, in close-quarter remodels, and on right-angle drills where the head crowds the bit. Bores clean, fast holes in framing lumber, plywood, soft hardwoods, and most wood-based materials.
- Cutting diameter: 1/2"
- Overall length: 4"
- 1/4" hex quick-change shank fits all standard hex chucks and quick-change adapters
- Hardened high-carbon steel construction stays sharp longer than mild-steel bits
- Standard arched cutting spurs define a clean hole edge and clear chips quickly
- Tri-point tip with center spur for accurate, walk-free starts
- Flat ground cutting zone -- re-sharpen with a common flat file
- Heavy-duty single-piece construction shank eliminates flex and bit wobble
- Black oxide finish resists corrosion in damp framing and weatherized job sites
Tip: The 1/2" diameter is sized for 1/2"-13 hardware clearance, NM-B 12/2 and 14/2 cable runs through framing, 1/2" PEX rough-in. Step up to the 6" length for general framing work where the bit can clear, or to the 12" length when drilling through double top plates or back-to-back stud bays.
