Workhorse 6-inch wood-boring spade bit for general framing, electrical, and plumbing rough-in. The advanced cutting design with arched cutting spurs defines the hole edge, removes chips faster, and increases cutting speed compared to older spade-bit designs.

• Cutting diameter: 3/4"
• Overall length: 6"
• 1/4" hex quick-change shank fits all standard hex chucks and quick-change adapters
• Hardened high-carbon steel construction stays sharp longer than mild-steel bits
• Raker spurs with 15-degree cutting wedge bore faster, smoother holes
• Tri-point tip with center spur for accurate, walk-free starts
• Flat ground cutting zone -- re-sharpen with a common flat file
• Heavy-duty single-piece construction shank eliminates flex and bit wobble
• Black oxide finish resists corrosion in damp framing and weatherized job sites

Tip: The 3/4" diameter is sized for workhorse pass-through for 3/4" PEX and CPVC supply lines, 3/4" EMT conduit, bundled low-voltage runs. For tight quarters between joists or inside cabinets, drop down to the 4" Stubby length. For through-stud reach in cable and plumbing runs, step up to the 12" length.

FOR CALIFORNIA SHOPPERS

Hello Californians! Your government wants us to show you the following message:

• ⚠  WARNING: This product and the dust created by its use may contain chemicals including lead known to the State of California to cause cancer birth defects or other reproductive harm. For more information go to www.p65warnings.co.gov