Carbide-tipped masonry drill bit designed for boring clean holes in brick, block, and concrete. The 1/4" universal hex shank seats into Rapid Load quick-change chucks for tool-free swaps, and also fits any standard hex bit holder or three-jaw drill chuck so it works across cordless drills, corded drills, and hammer drills in rotary-only mode.

• Tip diameter: 5/32"
• Carbide cutting tip for masonry materials
• 1/4" hex shank, Rapid Load / quick-change compatible
• For brick, block, and concrete drilling
• Rotary-only mode (not for SDS hammer-impact)
• Hex flats resist slip and walking in the chuck

Application: 5/32" is the standard pilot size for 3/16" tapcons, plastic anchors, and light-duty fasteners in masonry. Use it to set anchor sleeves for picture hooks, electrical box clips, and surface-mount conduit straps.

Tip: Run a cordless drill at moderate speed with steady pressure, and pull the bit out every few seconds to clear dust from the flutes - heat and dust loading are the leading causes of carbide tip failure. For deeper or harder concrete holes, switch a hammer drill to rotary-with-hammer mode; this bit handles rotary-with-hammer percussion but is not designed for SDS-style impact.

FOR CALIFORNIA SHOPPERS

Hello Californians! Your government wants us to show you the following message:

• ⚠  WARNING: Some dust created by power sanding sawing grinding drilling and other construction activities contains chemicals known to the State of California to cause cancer birth defects or other reproductive harm.