Watts ANKA glass-fiber-reinforced nylon barb tee for poly pipe and braided vinyl hose. Three blue captive Easy Grip nuts clamp pipe onto each barb leg - no separate hose clamps needed. Corrosion-proof nylon body, ideal where steel fittings would rust or where weight on the line is a concern. Typical uses at 1" include main irrigation supply, sump and transfer pump discharges, and rural water-line runs.

• Connection: 1" barb x 1" barb x 1" barb (run x run x branch)
• Glass-fiber-reinforced nylon body - lightweight, corrosion-proof
• Three blue captive Easy Grip nuts - hand tighten then snug with a wrench, no separate clamps
• For polyethylene pipe, braided vinyl tubing, and garden-hose-grade reinforced hose
• Working pressure: 230 PSI maximum
• Operating temperature: up to 140 deg F
• Reusable - can be disconnected and reconnected without damaging the fitting

Tip: Cut poly pipe square and warm the pipe end with hot water before pushing it onto the barb - cold poly resists the barb and the nut threads will cross. Tighten each captive nut just past the point where pulling on the pipe no longer slips; don't over-torque or the nylon nut threads will strip.

FOR CALIFORNIA SHOPPERS

Hello Californians! Your government wants us to show you the following message:

• ⚠  WARNING: This product contains chemicals known to the State of California to cause cancer and birth defects or other reproductive harm. For more information: www.watts.com/prop65