The Irwin 3/16" glass and tile drill bit uses a precision-ground tungsten carbide spear point to cut clean, round holes in glass, ceramic tile, mirrors, and marble without chipping or cracking. A versatile size for plastic anchors, small mounting holes, and decorative work on fragile surfaces.

• 3/16" cutting diameter with tungsten carbide spear-point tip
• Cuts glass, ceramic tile, mirrors, and marble
• Spear-point design minimizes chipping and breakout at start of cut
• Straight shank fits standard 3-jaw drill chucks
• Long-lasting carbide construction for repeated use

Tip: Mark the drill point with masking tape to prevent wandering, run the drill at a slow speed with light pressure, and keep the surface wet to control heat and extend bit life. Avoid hammer-drill mode on glass or tile - it will crack the workpiece.