Modern Masters Metal Effects Oxidizing Copper Paint is a water-base, modified acrylic paint with a high concentration of real copper particles. It tarnishes naturally over time when exposed to the elements, and Metal Effects Green Patina Aging Solution speeds that oxidation up to create an authentic green patina finish in minutes. The entire system can be applied to any properly prepared surface, including metal, wood, drywall, plaster, paintable wall coverings, canvas or muslin, and plastic.

• Water-base modified acrylic loaded with real copper particles; copper and iron pigment
• Prime first with at least two coats of Metal Effects Primer (AM203) to completely seal and block the surface; other primers let the aging solution reach the substrate and ruin the finish
• Apply two coats, then apply Metal Effects Green Patina Aging Solution (PA901) while the second coat is still wet, within 5 minutes
• Brush, roll or spray apply; do not apply below 55 deg F or above 85 deg F
• Recoat in 2 hours, dry to touch in 1 hour, handle in 2 hours, full cure in 3 to 4 hours at 77 deg F and 50% relative humidity
• Practical coverage 210-270 sq. ft. per gallon at recommended dry film thickness, allowing 15% material loss
• VOC content: less than 100 g/l; cleans up with soap and warm water
• Interior and exterior use on walls, moldings, trim, columns, doors, railings, lamps, vases and planters
• Size: 6 oz

Note: A clear topcoat is not required over a patina finish unless the surface gets repeated hand contact, such as a handrail. If one is wanted, use Metal Effects Permacoat Xtreme (AM204). Do not use other sealers or varnishes.

FOR CALIFORNIA SHOPPERS

Hello Californians! Your government wants us to show you the following message:

• ⚠  WARNING: Cancer and Reproductive Harm www.P65Warnings.ca.gov