National Hardware bar-type utility pull with rounded bow profile for comfortable grip on screen doors, drawer fronts, tool chest lids, shed doors, gates, and equipment lockers. Stamped steel body with white powder-coated finish to match white-framed storm/screen doors and painted cabinetry; mounting screws included.

• Overall length: 5-3/4"
• Projection from mounting surface: 1-3/8"
• Body: stamped steel
• Finish: white powder coat
• Mounting hardware: two wood screws included
• Use on: wood or metal doors, drawer fronts, tool chest lids, screen doors, gate panels, shed doors, equipment lockers, large drawers

Installation Tip: Position the pull at a comfortable hand height for the application - typically 36" to 42" off the floor for screen and shed doors, or centered on drawer or lid faces. Mark and pilot-drill both screw holes through the panel; oversize pilots slightly in hardwood and use sheet-metal screws instead of the supplied wood screws on steel doors. For panels thicker than 1-1/2" or for pulls that will see heavy daily use, step up to longer #10 wood screws so the pull anchors into structural framing rather than just the door skin.

Finish Selection Tip: White powder coat is the standard match for white-framed aluminum and vinyl storm and screen doors as well as painted-white interior cabinetry and farmhouse-style built-ins. For sheltered exterior use the powder coat resists chalking and yellowing better than painted finishes; step up to galvanized or zinc-plated for harsh outdoor sun and salt exposure where coat wear is a concern.

Note: Rated for hand-pull operation, not as a load-bearing carry handle. For luggage, tool, or equipment cases that will be lifted by the handle, step up to a load-rated chest handle line.