DeWalt DCS16 series 16-gauge straight finish nails are designed for interior trim and finish work. Made from galvanized carbon steel with a chisel point for reduced material splitting, these nails deliver consistent drivability in 16-gauge straight finish nailers.

• Size: 2" length, 16-gauge shank
• Material: galvanized carbon steel
• Point: chisel point reduces splitting in trim and panel stock
• Collation: smooth shank, straight (0-degree) strip - the standard 16-gauge finish nailer load
• Interior use only - galvanized coating is not weather-rated for direct exterior exposure
• Compatible with DeWalt DCN660, DWFP71917, and other 16-gauge straight finish nailers from Bostitch, Senco, Hitachi/Metabo HPT, Paslode, Porter-Cable, Ridgid, and Makita
• Box count: 2,500 nails per box

Length Use Case: Full-thickness baseboards, two-piece crown assemblies, larger casings, and stair skirt-board attachment through drywall into wood framing.

16-Gauge vs 18-Gauge: Pick 16-gauge for structural trim that needs to hold under stress - baseboards, door casings, window stools, chair rail, and thick crown molding. Step down to 18-gauge brads on delicate shoe molding, thin paneling, or applique work where a 16-gauge head would split the stock or telegraph through paint.

Tip: Set the nailer depth one click shy of flush on first contact and check the test piece - the galvanized coating slows the chisel point a hair, so depth dialed in for plain bright nails may drive these too deep. Adjust up one click if the head dimples the surface.