One-piece cast red brass cap that closes off the end of a 3/4" male-threaded pipe or fitting. The female American Standard Taper Pipe Threads seal against brass or steel pipe, and the lead free red brass is made for potable water service.

• Female pipe thread (FPT) - threads onto male NPT pipe and fittings
• One-piece construction, cast red brass per ASTM B584
• Conforms to ANSI/ASME B16.15, ANSI B1.20.1 and Federal Specification WW-P-460
• Rated 125 WSP / 200 WOG - intended for low to medium pressure service
• Fair vibration resistance
• Use with brass or steel pipe
• Lead free red brass: no more than 0.25% weighted average lead content on wetted surfaces, meeting Federal Public Law 111-380, California AB 1953, Maryland HB-372 and Louisiana Act 362

Tip: Apply PTFE (Teflon) tape or pipe sealant to the male threads, then tighten the cap about 2-1/2 turns past finger tight. Tapered pipe threads seal on the thread flanks, so do not try to stop a weep by overtightening - back off, re-tape and retighten instead.

FOR CALIFORNIA SHOPPERS

Hello Californians! Your government wants us to show you the following message:

• ⚠  WARNING: This product can expose you to lead a chemical known to the State of California to cause cancer and reproductive harm. www.P65Warnings.ca.gov