Gardner Bender WireGard Connector - Red GB-6, 25pk
Gardner Bender WireGard Connector - Red GB-6, 25pk
Gardner Bender WireGard Connector - Red GB-6, 25pk
Gardner Bender WireGard Connector - Red GB-6, 25pk
Gardner Bender WireGard Connector - Red GB-6, 25pk

Available Colors:

Description:

Item # 9W79H8UPC: 032076002558
GARDNER BENDER WIREGARD WIRE CONNECTOR - RED (GB-6), 25 PACK

Gardner Bender WireGard red (GB-6) wire connectors are color-coded for quick gauge identification and engineered for copper-to-copper wire splicing. The red GB-6 is the largest connector in the line for heavy splicing, sized for splices in the #18-#10 AWG range. Square-wire zinc-plated steel springs grip each conductor independently, and the flame-retardant polypropylene shell shrugs off heat and physical abuse in junction boxes and fixture cavities.

  • Wire range: #18-#10 AWG (copper to copper only - NOT for aluminum conductors)
  • Square-wire zinc-plated steel spring grips conductors independently for vibration-resistant splices
  • Flame-retardant polypropylene shell rated to 221 deg F (105 deg C) max
  • Rated 600V max in building wire, 1000V max in fixtures and signs
  • Color-coded shell (Red = GB-6) for fast at-a-glance gauge identification
  • UL 486C Listed and CSA Certified for code-compliant residential and commercial use
  • 25 connectors per bag

Tip: GB-6 Red handles the largest splices in the WireGard line: 12 AWG and 10 AWG branch-circuit conductors, range and dryer feeders, panel neutral and ground splicing, and multi-conductor 12 AWG splices in oversized junction boxes. Pre-twist 10 AWG conductors with linesman pliers before applying the connector.

Install: Strip about 5/8 inch of insulation from each conductor, hold the conductors parallel with the ends aligned, and twist the connector clockwise until tight. Pre-twisting solid copper conductors with linesman pliers before applying the connector is recommended on 12 AWG and 10 AWG splices where vibration is a concern (junction boxes near appliances, attic-mounted lights, garage-door openers). A finished splice should not pull apart under a firm tug, and no bare copper should show below the connector skirt.

Color code reference: WireGard color codes: GB-1 Gray (#22-#16), GB-2 Blue (#22-#16), GB-3 Orange (#22-#14), GB-4 Yellow (#18-#10), GB-6 Red (#18-#10). Always step up to the next size when in doubt - oversized connectors can spin loose, undersized connectors don't fully engage the spring.


FOR CALIFORNIA SHOPPERS

Hello Californians! Your government wants us to show you the following message:

  • ⚠  WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov.