Hardened steel cut nails for fastening wood to concrete, cinder block, and masonry. The rectangular tapered shank wedges into the masonry as it's driven, gripping by friction along its full length and resisting pull-out far better than smooth wire nails. The blunt point minimizes spalling around the entry point, so the surrounding masonry stays intact.

• 8d penny size, 2-1/2" long
• Tapered rectangular shank for high pull-out resistance
• Blunt point minimizes masonry spalling
• For fastening furring strips, floor plates, partition wall sole plates, and 1x trim to concrete or cinder block
• 1 lb box (approximately 90-100 nails)

Best for: 1 lb pack covers patch and repair work - re-securing a single loose furring strip, tacking baseboard or shoe molding over a slab, or a small one-room project where you only need a handful of nails.

Tip: Drive with a heavy hammer (20-24 oz framing) at a slight angle and aim for 3/4" minimum penetration into the masonry. For dense or aged concrete, pre-drill a slightly undersized pilot with a masonry bit to keep the nail from snapping. Always wear safety glasses - cut nails are brittle and can shatter on a miss-hit.