Fixed-pattern pop-up spray head for in-ground residential irrigation systems. Delivers a rectangular side-strip spray pattern designed to cover narrow lawn areas -- sprays out one side of the head, for use along the edge of a strip. Fits standard 1/2" NPT risers and pops up 2" above the turf when the zone runs.

• Side strip pattern fixed nozzle (sprays out one side of the head, for use along the edge of a strip)
• Rectangular coverage roughly 5 to 30 Ft long -- sized for parking strips, borders, and narrow side yards
• 2" pop-up height clears typical mowed grass
• Pre-installed pressure regulator maintains 30 PSI at the nozzle for even droplet size and consistent throw
• Prevents misting caused by high line pressure -- less water waste, less overspray onto walkways
• 1/2" female NPT inlet -- compatible with standard poly riser tees and swing pipe
• Reinforced cap threads and strengthened inlet filter resist grit and repeat winter freezes
• Model 80354

Installation Tip: Position strip heads so the pattern axis aligns with the long dimension of the lawn strip. Set the head flush with finished grade to avoid mower damage. After turning the zone on, flush the line briefly before threading the head onto the riser to clear debris.

Note: Fixed-pattern strip heads do not adjust after installation -- pick center vs end vs side strip based on where the head sits in the run. Strip nozzles apply less water per minute than radial heads, so keep them on their own zone or match precipitation rate.