Built for impact drivers and standard drills, the Century Impact Pro 11/64" drill bit is made from premium M2 high-speed steel and carries a 1/4" quick-change hex shank, so it drops into any cordless impact driver or quick-change drill chuck without slipping.

• Premium M2 high-speed steel withstands heat and wear under rigorous drilling applications
• Single-piece, fully ground construction lasts 6x longer than two-piece constructed drill bits
• Century 135-degree quick-cut point is self-centering and penetrates faster with less pressure - no center punch needed
• Will not walk or wander at the starting surface
• 1/4" quick-change hex shank fits all quick-change adapters and cordless impact tools
• Black oxide finish for added lubricity and corrosion resistance
• General-purpose drilling in metal, wood, and plastic
• Bit diameter: 11/64"
• Overall length: 2-7/8"

Application Tip: 11/64" is the standard hardwood pilot hole for #14 wood screws, and the intermediate step between 5/32" and 3/16".

Drilling Tip: The 1/4" hex shank lets you run this bit in either a drill or an impact driver, but the right speed depends on material. For metal: slow drill speed (under 1000 RPM on small bits, slower on larger), use cutting oil, and let the bit cut without pushing. For wood and plastic: medium-to-high speed, clear chips on the way back out. In an impact driver: short trigger pulls work best - long sustained impact can overheat the bit on metal and dull the cutting edge.

FOR CALIFORNIA SHOPPERS

Hello Californians! Your government wants us to show you the following message:

• ⚠  WARNING: This product and the dust created by its use may contain chemicals including lead known to the State of California to cause cancer birth defects or other reproductive harm. For more information go to www.p65warnings.co.gov