NATIONAL HARDWARE 3" SPRING DOOR STOPStop the doorknob from punching a hole in your drywall. This 3" spring door stop from National Hardware mounts to the baseboard or wall behind the door, and the flexible steel coil bends as the door swings into it to absorb impact. A rubber bumper tip caps the spring so contact stays quiet and leaves no marks on the door. Same dependable design that has been protecting walls and trim in homes, apartments, and offices for decades.
- 3" steel coil spring flexes on contact to absorb door impact and prevent wall damage
- Rubber bumper tip cushions the strike point and protects the door face from scuffs
- Wide base plate distributes load and screws flat against baseboard or wall
- Spring threads off the base plate so the plate can be mounted first, then the spring installed
- Surface-mounted - no door modification, no hinge-pin attachment, works on any swinging interior door
- Steel construction with decorative finish to coordinate with door hardware and switch plates
- Mounting screws included
- Lifetime limited warranty from National Hardware
Installation Tip: Mount the base plate on the baseboard directly in line with the doorknob when the door is open against it, far enough out from the hinge that the door clears the spring before the spring reaches full deflection. Pre-drill pilot holes in hardwood baseboards to avoid splitting; in drywall, drive the screws into a stud where possible or use a small drywall anchor.
Finish Selection Tip: Match the finish to your door hardware and hinges. Satin Nickel pairs with brushed nickel knobs and modern lighting. Oil Rubbed Bronze suits warm-tone bronze knobs, rustic, and traditional decor. Brass coordinates with polished brass and antique brass hardware. White blends into white baseboards and painted trim so the stop disappears visually. Matte Black ties into modern, industrial, and farmhouse fixtures.