The Linzer Pro-Maxx is a hand-crafted angle sash brush built around blended polyester filaments that hold their tip and snap back into shape between strokes. The angle cut is the standard profile for cutting in wall-to-ceiling lines, cutting around trim and windows, and laying off the final brushstrokes on door panels and cabinetry. The 3" width is the largest size in the line and is the right pick when you have substantial linear footage to cover - long baseboard runs, casing returns, exterior fascia, and full-area sash work where the brush itself is the primary applicator rather than just a cut-in tool.

• Width: 3"
• Filament thickness: 11/16"
• Bristle: blended polyester (long-lasting tip, holds shape)
• Profile: angle sash for cutting-in corners, trim, and edge work
• Handle: natural wood
• Ferrule: stainless steel (rust-resistant for water-based work)
• Use with all latex, oil-based paints, primers, and stains

Cleaning Tip: For latex paint, rinse under warm water and work the soap into the heel of the brush with your fingers until the rinse runs clear. For oil-based finishes, work mineral spirits through the bristles and into the heel, then finish with a soap-and-water rinse. Spin out water, comb the bristles straight with a brush comb, and hang or store flat in the cardboard keeper - never bristles-down in a drawer.