Braided stainless steel dishwasher water supply connector with a polymer core, 72-inch length, and 3/8" Comp x 3/8" Comp fittings. Includes a 90-degree elbow for tight final connections behind the dishwasher. Sized for longer runs - kitchens with the dishwasher set away from the angle stop, or when extra slack is needed for service pullout.

• 304 stainless steel braid - approximately 220 ft of wire per foot of connector
• Tough polymer core resists chlorine, chloramines, and water hammer
• Extra-long stainless ferrules with radial crimps for leak-free joints
• Captive cone washer at the compression end will not fall out during install
• NSF/ANSI 61 listed for potable water service
• End fittings: 3/8" Comp x 3/8" Comp
• Length: 72"
• Includes: 90-degree elbow
• Will not kink, crease, or balloon under pressure

Which model do I need? Match the end fittings to your dishwasher inlet and angle stop. 3/8" Comp x 3/8" Comp with 90-degree elbow fits most modern dishwashers - the included elbow lets you make a tight final turn behind the cabinet kick plate.

Tip: Do not twist the connector during install - turn the nut, not the hose. Hand-tighten plus 1/4 to 1/2 turn with a wrench; over-tightening crushes the cone washer and starts a slow drip that takes weeks to show under the cabinet.

FOR CALIFORNIA SHOPPERS

Hello Californians! Your government wants us to show you the following message:

• ⚠  WARNING: Cancer and Reproductive Harm www.P65Warnings.ca.gov