Braided stainless steel toilet supply line with Texas fine-flare thread on the toilet end and a 1/2" FIP nut on the wall end. The fine-flare thread is the legacy connection found on a small number of older Texas-pattern toilet ballcocks, where a standard 7/8" ballcock nut will not seat. Connects the angle stop at the wall to the toilet tank fill valve. The 16" length covers installations where the angle stop sits further from the toilet base.

• 16" overall length
• 1/2" FIP nut (wall side, fits standard 1/2" compression or threaded angle stop)
• 7/8" Texas fine-flare ballcock nut (toilet side)
• Braided stainless steel jacket over an EPDM inner hose
• Lead-free brass connectors
• Burst-tested and rated for continuous supply pressure

Selection: Verify your ballcock uses Texas fine-flare thread before ordering. Most modern toilets use a standard 7/8" coarse ballcock nut and need a standard connector, not the fine-flare version. If you're not sure, take the old line to your local plumbing counter for a thread check.

Installation: Shut the angle stop, drain the tank, replace the line, and turn the stop on slowly while watching both ends for weeping before flushing.