Extended-length wood installer bit for running cable, wire, and low-voltage runs through stud bays, top plates, and stacked floor framing. The ultra-sharp tip starts on-mark for straight pilot holes, and the wire-pull hole near the tip lets you hook your cable and pull it back through the hole in one pass - no fishing, no second drilling.

• Diameter: 1/2"
• Overall length: 18"
• Wire-pull eyelet through flute near tip
• Ultra-sharp tip for fast, straight holes in wood and stacked lumber
• Black oxide coated flutes resist heat and friction
• 3-flat shank prevents bit slip in keyless and keyed chucks
• For cordless and corded drill drivers

Tip: Drive at moderate speed and steady pressure - the long flute body can flex if you push hard. After breaking through the far side, slip your cable into the eyelet and reverse the drill out to pull the run through.