Amerimax 24" x 10 Ft galvanized roll valley flashing channels water down the V where two roof slopes meet, and serves as a workable raw stock for custom drip edges, step flashing, sidewall flashing, and field-bent transitions. The 32 gauge steel carries a zinc coating that resists rust and corrosion through years of weather exposure on residential and light commercial roofs.

• Material: 32 Gauge Galvanized Steel with zinc coating that repels rust
• Width: 24"
• Length: 10 Ft per roll
• Workable stock for custom flashings, drip edges, and pre-bent transitions
• Cuts cleanly with tin snips and bends by hand or with a sheet-metal brake
• Resists corrosion for long-lasting performance on exterior roof and wall applications
• Helps prevent moisture penetration at roof valleys and other vulnerable joints

Tip: The widest 24"-36" rolls are used for wide open valleys, oversized drip edges, and commercial details where a single piece spans the full flashing run. 10 Ft rolls are sized for repairs, short valley sections, and small flashing details where a 25 or 50 foot roll would leave excess on the job.