Braided stainless steel toilet supply line with Texas fine-flare thread on the toilet end and a 3/8" compression nut on the wall end. The fine-flare thread is the legacy connection found on a small number of older Texas-pattern toilet ballcocks, where a standard 7/8" ballcock nut will not seat. Connects the angle stop at the wall to the toilet tank fill valve.

• 12" overall length
• 3/8" compression nut (wall side, fits standard 3/8" compression angle stop)
• 7/8" Texas fine-flare ballcock nut (toilet side)
• Braided stainless steel jacket over an EPDM inner hose
• Lead-free brass connectors
• Burst-tested and rated for continuous supply pressure

Selection: Verify your ballcock uses Texas fine-flare thread before ordering. Most modern toilets use a standard 7/8" coarse ballcock nut and need a standard connector, not the fine-flare version. If you're not sure, take the old line to your local plumbing counter for a thread check.

Installation: Shut the angle stop, drain the tank, replace the line, and turn the stop on slowly while watching both ends for weeping before flushing.