Charlotte Pipe 6" elbow makes a right-angle turn in drain, waste, and vent piping. Sometimes called a quarter bend, this fitting changes flow direction by 90 degrees at corners and where the line transitions between vertical and horizontal runs.

• 6" hub x hub configuration, both ends accept pipe
• Schedule 40 PVC, DWV rated
• Dual-rated for pressure piping (ASTM D1785) and drainage (ASTM D2665)
• Meets ASTM D3311 and NSF Standard 14
• Working temperature up to 140 deg F

Tip: On long horizontal drain runs, a long-sweep elbow or two 45-degree bends will flow better than a hard 90 and reduce stoppage points. Install with PVC primer and DWV-rated solvent cement.