1/2" compression tee in lead-free yellow brass. Creates a three-way branch in copper, aluminum, brass, or plastic tubing using compression fittings - no flaring, soldering, or threading required. The lead-free alloy is compliant with the federal Safe Drinking Water Act for potable water service.

• Connection: 1/2" compression on all three ends
• Tube OD: 1/2" (fits 1/2" copper, brass, aluminum, polyethylene, or nylon tubing)
• Material: lead-free brass alloy
• Lead-free per NSF/ANSI 61 and 372; meets federal Safe Drinking Water Act requirements
• Applications: potable water, gas, oil, air, and instrument tubing branches

Tip: Slide the compression nut and brass ferrule onto the tubing before seating the tube against the shoulder of the fitting body. Hand-tighten the nut, then wrench-tighten roughly 1 to 1-1/4 turns past finger-tight to set the ferrule and seal the joint. Do not over-tighten - the ferrule deforms only once.

FOR CALIFORNIA SHOPPERS

Hello Californians! Your government wants us to show you the following message:

• ⚠  WARNING: This product can expose you to lead a chemical known to the State of California to cause cancer and reproductive harm. www.P65Warnings.ca.gov