Reverse-orientation tooth grind pulls chips toward the work face instead of away from it, preventing top-surface splintering on plywood, melamine, laminate countertops, and veneered panels. Cut with the finish side up and get a clean edge on the visible face.

• 4" overall blade length
• 10 TPI (teeth per inch) for downcut wood cutting
• High Carbon Steel (HCS) construction for long-lasting sharp cuts in wood
• T-shank fits standard DeWalt, Bosch, Makita, Milwaukee, Skil, Ridgid, Ryobi, and Black & Decker jigsaws
• 5 blades per pack
• Use for: laminate countertops, melamine cabinet panels, pre-finished plywood, veneered hardwood, any finish-grade panel where the visible face is up during the cut

Tip: Downcut blades push sawdust onto the work surface rather than below it -- run dust collection close to the cut or vacuum periodically so the layout line stays visible.

FOR CALIFORNIA SHOPPERS

Hello Californians! Your government wants us to show you the following message:

• ⚠  WARNING: Some dust created by power sanding sawing grinding drilling and other construction activities contains chemicals known to the State of California to cause cancer birth defects or other reproductive harm.