This Anderson Metals lead free brass compression elbow creates a 90-degree turn in your tubing run. Both ends feature compression connections for use with copper, brass, aluminum, or plastic tubing. No soldering required. Meets all requirements for lead free installation per NSF/ANSI 372.

• 3/8" compression x 3/8" compression - 90-degree elbow
• Lead free brass construction meets NSF/ANSI 372 (no more than 0.25% lead by weighted average wetted surface area)
• For use with copper, brass, aluminum, or plastic tubing
• No soldering required - compression fitting design
• Suitable for water, gas, oil, and vacuum line applications
• Flag tagged for retail display, bulk packed

Tip: Use a tubing cutter for clean, square cuts so the ferrule seats properly. Slide the compression nut onto the tubing first, then the ferrule (sleeve), then insert the tubing fully into the fitting body. Hand-tighten the nut, then finish with one to one-and-a-half turns of a wrench. Overtightening deforms the ferrule and causes leaks.

FOR CALIFORNIA SHOPPERS

Hello Californians! Your government wants us to show you the following message:

• ⚠  WARNING: This product can expose you to lead a chemical known to the State of California to cause cancer and reproductive harm. www.P65Warnings.ca.gov