Mibro twisted polypropylene rope is a versatile general-purpose utility rope that floats on water and resists rot, mildew, oil, gasoline, and most common chemicals. The UV-stabilized bright yellow construction provides high visibility for safety and easy spotting during marine, agricultural, and outdoor work. The three-strand twisted construction holds knots securely and splices cleanly for eye terminations or end loops.

• Diameter and length: 3/8" x 50 ft
• Safe working load: 244 lb (industry standard 10:1 safety factor)
• Floats on water - ideal for marine, dock, pool, and water rescue use
• Resists rot, mildew, oil, gasoline, and most chemicals
• UV-stabilized polypropylene for extended outdoor exposure
• Three-strand twisted construction - easy to splice, easy to knot
• Lighter per foot than nylon or manila for the same diameter
• Bright yellow for high visibility against grass, deck, and water
• Hank packaged for tangle-free pay-out and storage

3/8" is the medium-utility workhorse - dock line for canoes and small jon boats, anchor line on quiet water, livestock tie-out, swing rope, tarp ridge line, securing furniture or appliances in a pickup, and pulling small loads without shock impact.

The 50 ft hank is sized for single-job tie-downs, garage and shop storage, one-tarp lashing, and short pickup-bed loads where you don't need a full reel.

Tip: Singe freshly cut ends with a lighter or match to fuse the strands and prevent unraveling. For load-bearing knots use a bowline, double sheet bend, or anchor bend - avoid square knots under load. Polypropylene weakens with prolonged direct sunlight (typically 2-3 seasons of continuous UV); inspect before each use for fuzzed strands, broken yarns, or a glazed surface and retire the rope if any of those are present.

Care: Coil loosely and store dry and out of direct sun. Do not use this rope on running winches or capstans - twisted polypropylene melts at low friction temperatures. Avoid loads exceeding the rated safe working load. Polypropylene shows little warning before failing under shock load, so size up a diameter if there is any chance of jerking or sudden impact.