Cantex Type LL conduit body provides a 90-degree direction change for Schedule 40 or Schedule 80 rigid PVC conduit while keeping wiring accessible. The removable cover lets you pull wire during install and rework the circuit later without cutting conduit.

• Size: 1-1/2" solvent-weld socket on both hubs
• Type LL: one hub on the end wall (in line with the cover) and one hub on the left side wall, viewed cover-face up
• Molded from the same Cell Classification 12454-B PVC compound used in Cantex Schedule 40/80 conduit
• Fits standard PVC Schedule 40 and Schedule 80 rigid conduit
• Sunlight-resistant; indoor or outdoor; non-conductive (no separate bonding required)
• UL 514C listed for nonmetallic conduit fittings

Tip: Solvent-weld assembly - wipe both surfaces clean, apply PVC primer (purple) to the hub socket and conduit end, then PVC cement, push fully home with a 1/4 turn, and hold 30 seconds. The standard cover is not rainproof on its own; for wet, outdoor, or wash-down locations install the matching Cantex gasket/cover kit (sold separately) so the cover seals against the body.