Single cutter design bores clean holes in wood and nail embedded wood, so the bit keeps cutting when it meets a nail during remodel and demolition work. A hollow center flute clears chips aggressively on deep holes, and the non-stick epoxy coating is made for cutting green and sappy woods. Bores holes in all types of woods where deep, clean holes are required.

• Single cutter design cuts through wood and nail embedded wood
• Hollow center flute for aggressive chip removal
• Non-stick epoxy coated for green and sappy woods
• 5/8" cutting diameter
• 18" overall length
• 3/8" hex shank - 0.43" across the corners, so it needs a 1/2" or larger chuck
• Part of Century's 18" nail cutter line, offered from 3/8" to 1-1/2"

Tip: The 18" figure is overall length. The chuck grips part of the shank and the cutting head takes up more, so usable boring depth is less than 18" - measure your stock before you commit to a hole.

FOR CALIFORNIA SHOPPERS

Hello Californians! Your government wants us to show you the following message:

• ⚠  WARNING: This product and the dust created by its use may contain chemicals including lead known to the State of California to cause cancer birth defects or other reproductive harm. For more information go to www.p65warnings.co.gov