Full-grain cowhide leather work gloves built for everyday durability and palm-side abrasion resistance. The natural cowhide skin breathes, conforms to the hand with use, and shrugs off splinters, rough lumber, and concrete edges that destroy fabric gloves. A gunn-cut pattern moves the finger seams away from the gripping surface so they do not wear under the palm, and the keystone thumb is stitched as a separate piece for natural thumb travel and improved dexterity. Suited to yard work and landscaping, lumber and material handling, fencing, masonry block work, light demo, hauling, and general utility tasks where bare-hand grip without leather protection would shred the skin.

• Full-grain cowhide leather palm, back, and fingers
• Gunn-cut pattern - finger seams sit out of the high-wear palm area
• Keystone thumb sewn as separate piece for natural thumb motion
• Seamless back of hand for smooth, snag-free coverage
• Shirred elastic wrist seals out dirt, dust, and chips
• Size: Medium (Boss MPN B81192-M)

Sizing Tip: Leather gloves stretch slightly with use, so start with a snug fit at the palm and let the leather break in. Measure hand circumference around the palm at the knuckles - roughly 8" for Medium, 9" for Large, 10" for X-Large, and 11"+ for 2X-Large. If the finger seams extend past the fingertips, drop a size; if knuckles bind, step up.

Care Tip: Brush off dust and let gloves air-dry naturally; do not put leather work gloves in a dryer or near a heat source - it cooks the leather stiff. A light coat of leather conditioner or saddle soap once a season keeps the cowhide pliable and extends service life. Replace when palm wears thin or seams begin to open.